Wireless Remote Adapter Tascam RC-402
Works with the following decks Tascam BR-20, MSR16, MSR24 and TSR-8
Last update May 12, 2021
This unit controls the standard transport controls Play, Stop, Fast Forward, Rewind, Record and Lifter Defeat. It uses any standard universal remote programmed to control a Sony VCR.
I sell this on eBay for $80 or buy direct for $75 plus shipping of $8 within the US or $25 outside the US.
Contact me at scott@revoxremotes.com
Instructions
Installation: Turn off the power to the tape deck. Plug the remote adapter into the Accessory 1 connector on the back of the deck. Now power can be turned back on. The light on the front of the remote adapter should be on.
The remote adapter controls the standard 5 transport functions: Play, Stop, F.F., Rewind, Record and Lifter Defeat. All functions can be controlled using any universal remote programmed for the proper Sony VCR code.
The remote adapter can be programmed to respond to Sony VHS VCR, Beta VCR, 8mm VCR and Laser Disc Player codes. To select between the four options there are two jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover.
Toward the front window are set of jumpers. The two jumpers labeled 1 and 2 configure the remote device code per the table below.
JMP1
|
JMP2 |
Device |
DirecTV
Remote |
RCA |
JMP*
|
JMP* |
Beta |
20033
|
VCR-119 |
JMP
|
OPEN
|
8mm
VCR |
20034 | VCR-098 |
OPEN
|
JMP
|
VHS
VCR |
20032 | VCR-099 |
OPEN
|
OPEN |
LDP |
---- |
---- |
* = Default jumper selection
Configuring the RCA Universal Remote
To program the RCA remote press and hold the Code Search button until the
red light comes on. Release the Code Search button and momentarily press the
VCR button then enter the 3 digit code from the table above (default is 119).
The red light should blink after each keypress and go out after the last digit
is entered. Press the VCR button and press one of the transport control buttons
(PLAY, STOP, FF, REW or REC). The light on the front of the remote adapter should
blink off momentarily. If the light does not blink off try reprogramming the
remote or check the state of the jumpers inside the remote adapter. On the RCA
remotes the REC button needs to be pressed twice to activate record. RCA
RCU-1300 manual and code list.
Configuring the DirecTV Universal Remote
To program the DirecTV remote first slide the switch at the top to AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5-digit device code from the table above. If done correctly the green light will blink twice after the last digit is entered. On the DirecTV remotes the REC button needs to be pressed twice to activate record. DirecTV manual and code list.
For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here
Remote adapters are also available for Aiwa, Akai, Ampex, Crown, Denon, Nakamichi, Otari, Pioneer, Revox, Sony, Studer, Tandberg, Tascam, Teac and Technics decks.