Teac RC-90 Wireless Remote Adapter

Ready to ship
I sell this on eBay for $74 or buy direct for $69 + shipping of $8 within the US or $23 outside.

Contact me at scott@revoxremotes.com
scott@revoxremotes.com is also my PayPal account

Compatible with Teac X-7, X-10, X-700, X-1000, X-1000M, A800 reel to reel decks well as the Teac C-1, C-2, C-2X, C-3X, C-3RX and Tascam 122 cassette decks.

Installation: Turn off the power to the tape deck. Plug the remote adapter into the remote connector on the back of the tape deck. Now power can be turned back on. The light on the front of the remote adapter should be on.

The remote adapter controls the following 7 functions: Play, Stop, F.F., Rewind, Record, Pause and Record Mute. All functions can be controlled using any universal remote programmed for the proper Sony VCR code.

The remote adapter can be programed to respond to Sony VHS VCR, Beta VCR, 8mm VCR and Laser Disc Player codes. To select between the four options there are two jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover.

Toward the front window are two jumpers labeled 1 and 2. They configure the remote device code per the table below.

JMP1

JMP2

Device
Code

DirecTV

RCA
Remote

JMP*

JMP*

Beta
VCR

20033

VCR-119

JMP
OPEN
8mm
VCR
20034 VCR-098
OPEN
JMP
VHS
VCR
20032 VCR-099
OPEN

OPEN

LDP

----

----

* = Default jumper selection

Configuring the RCA Universal Remote
To program the RCA remote press and hold the Code Search button until the red light comes on. Release the Code Search button and momentarily press the VCR button then enter the 3 digit code from the table above (default is 119). The red light should blink after each keypress and go out after the last digit is entered. Press the VCR button and press one of the transport control buttons (PLAY, STOP, FF, REW, REC or PAUSE). The light on the front of the remote adapter should blink off momentarily. If the light does not blink off try reprogramming the remote or check the state of the jumpers inside the remote adapter. On the RCA remotes the REC button needs to be pressed twice to activate record.

Configuring the DirecTV Remote: To program the DirecTV remote first slide the switch at the top to AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5 digit device code from the table above. If done correctly the green light will blink twice after the last digit is entered. The full manual for the DirecTV can be found here: www.revoxremotes.com/Remotes/DirecTV.htm

For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here

Remote adapters are also available for Aiwa, Akai, Ampex, Crown, Denon, Nakamichi, Otari, Pioneer, Revox, Sony, Studer, Tandberg, Tascam, Teac and Technics decks.